AeroGanja
In Bloom
Materials Needed:
Lighter
Plastic Straw
Pliers/Needlenose
Scissors
Directions:
1.) Cut desired length of straw
2.) Grab end of straw with pliers leaving 1-2mm of exposed plastic.
3.) Melt said plastic with lighter
--- at this point, I typically repeat 1-3 until I have all the sections I need/want----
4.) Place seeds in straw with sealed end down
5.) Grab end of straw with pliers (Be sure there is enough plastic to grab w/o crushing seeds) again leaving 1-2mm of exposed plastic
6.) Melt and seal
To open pinch end opposite of seal
Will upload pictures next time I do it, but hopefully the directions were detailed enough to get the jist.
Lighter
Plastic Straw
Pliers/Needlenose
Scissors
Directions:
1.) Cut desired length of straw
2.) Grab end of straw with pliers leaving 1-2mm of exposed plastic.
3.) Melt said plastic with lighter
--- at this point, I typically repeat 1-3 until I have all the sections I need/want----
4.) Place seeds in straw with sealed end down
5.) Grab end of straw with pliers (Be sure there is enough plastic to grab w/o crushing seeds) again leaving 1-2mm of exposed plastic
6.) Melt and seal
To open pinch end opposite of seal
Will upload pictures next time I do it, but hopefully the directions were detailed enough to get the jist.
