The humidity will cause issues worse than the stress from heat.
There's a clue. Heat rises, your second floor is warmer. I'd run a 4" flex line to the register in that room and draw cooler air from a lower point in the house. Set the duct in front of the register, and seal it with a lump of towels. Bonus points to use a 4" inline to actively draw the cooler air from lower parts of the dwelling.
I never thought of that. She's still standing as of now, so I'll have to take another peek.
Easy and best scope money can buy. I’d you have a smart phone that is but most do nowadays. Amazon.com/60xclipscope
It on the second floor of the north side. I can't open the window because it's a casement window that's in a small alcove that is completely filled with the grow tent, so I can't reach the window. At least the sun's not coming in on that side. However, perhaps you missed my later update, and my serious facepalm. During the winter the room can be a bit cool for growing, so I put heat mats under the pots and I completely forgot to unplug them when summer arrived. It should have been able to handle the air temp in the tent in the 80s, but the plant was baking from the bottom up. Those roots were roasting. I now have a couple auto plants in there that will finish in about 2 weeks and the tent environment is much better.
skimmed too fast, nice it was just those heat mats!
Unfortunately, this tent only has one door. I suppose that's not too surprising since it's only 3x3 and easy to reach across from the one. Outlets are another issue. I only have one in that room to run both tents (the second one is 2x2). Thankfully, neither the fans nor the LED quantum board lights for those small tents draw too much power. Even those heat mats are low wattage. But with those danged mats dealt with, I should be good now and this whole thread now stands as testament to my thick skull.
My old outlet was like that, inaccessible from the bed in the way (especially once things got big), and it had to go there. Even automated it with some bluetooth controls+damper so i didn't have to ever get back there. But my bed was getting too cold near the floor in the winter, even with good ambient temps so I made a dolly to raise it up a foot for the heat to reach under. and that exhaust setup was in the way yet again, so sealed it off and found a dif outlet spot eventually up high. I don't have to stoop so low trimming now, can rotate/move it when i drop scissors or spill soil/trimmings behind. but my little 24x24x36 wooden shanty box is stuck in place, want to put that on dolly wheels so it's like a rolling cab- and plop one of those 24"x24" ac infinity tents on top of it as an upgrade. It'd have a nice warm bottom from the cab below probably. I'm rambling now... but do those tents only unzip on one face or can you access it from the back too, if say I was to spin it around? For me, after 5 minutes it gets to be a pain in the neck reaching around in the back of a 2 foot space.
