Hemps Grow House
- Thread starter Hemp
- Start date
Hemp
In Bloom
So I was doing some reading one thing that I found out that I was doing wrong is when I do the silica and calcium magnesium. I have never read this before. I know about silica. You should add it first, but I never knew that calcium from advanced nutrients needed to be mixed before anything else. Of course, if I’m using silica, you make it first. But then I would go to a A&B and then add my calcium magnesium. I have even seen it in writing. But doing some studying because I’m noticing some lockout. It says to add silica first then calcium, magnesium, and then rest of your nutrients. It says actually to add the rhino skin for at least 15 minutes to 20 minutes before you add anything else. I’ve never had an issue with that, but I’m definitely going to pay attention to the calcium magnesium.
Hemp
In Bloom
Those will be very big plants. I have very good results out of the starter bags. And then go to the 1 gallon container. I can almost go two months and that 1 gallon container. When those get about a foot and a half tall, I’ll do the flip. I got to say that’ll be in about two weeks. They’re nice and dark. I’ll go ahead and start giving them water for the next few cycles. Lighten them up a little bit before the flip.
Chefdave
Tree of Life Genetics
Yeah man , very important to add silica first and let circulate or stir for 15 minutes before anything else. It negates precipitation normally caused from calcium or magnesium. Fallout or precipitation cause white particles which are unsoluable and unavailable to plants such as calcium silicate. For your setup, mixing should be water, rhino skin mixed for 15 minutes, then cal mag, then base ( a first, then b if using two part) then any pk boosters, and finally pH down if necessary
