Hemps Grow House

So I was doing some reading one thing that I found out that I was doing wrong is when I do the silica and calcium magnesium. I have never read this before. I know about silica. You should add it first, but I never knew that calcium from advanced nutrients needed to be mixed before anything else. Of course, if I’m using silica, you make it first. But then I would go to a A&B and then add my calcium magnesium. I have even seen it in writing. But doing some studying because I’m noticing some lockout. It says to add silica first then calcium, magnesium, and then rest of your nutrients. It says actually to add the rhino skin for at least 15 minutes to 20 minutes before you add anything else. I’ve never had an issue with that, but I’m definitely going to pay attention to the calcium magnesium.
 
Those will be very big plants. I have very good results out of the starter bags. And then go to the 1 gallon container. I can almost go two months and that 1 gallon container. When those get about a foot and a half tall, I’ll do the flip. I got to say that’ll be in about two weeks. They’re nice and dark. I’ll go ahead and start giving them water for the next few cycles. Lighten them up a little bit before the flip.
 
So I was doing some reading one thing that I found out that I was doing wrong is when I do the silica and calcium magnesium. I have never read this before. I know about silica. You should add it first, but I never knew that calcium from advanced nutrients needed to be mixed before anything else. Of course, if I’m using silica, you make it first. But then I would go to a A&B and then add my calcium magnesium. I have even seen it in writing. But doing some studying because I’m noticing some lockout. It says to add silica first then calcium, magnesium, and then rest of your nutrients. It says actually to add the rhino skin for at least 15 minutes to 20 minutes before you add anything else. I’ve never had an issue with that, but I’m definitely going to pay attention to the calcium magnesium.
Yeah man , very important to add silica first and let circulate or stir for 15 minutes before anything else. It negates precipitation normally caused from calcium or magnesium. Fallout or precipitation cause white particles which are unsoluable and unavailable to plants such as calcium silicate. For your setup, mixing should be water, rhino skin mixed for 15 minutes, then cal mag, then base ( a first, then b if using two part) then any pk boosters, and finally pH down if necessary
 
I always do the rhino skin the day before. But there has been a few times that I didn’t, but not much. But I never knew about the calcium and magnesium. Matter fact, this is the first time that I’ve ever seen anything about it but it’s OK. I usually configure things out right away. Either doing some research or asking. The small ones haven’t had anything like that at all. And I’m normally don’t start doing that stuff until I get ready to flip. If I am just doing one grow at a time is better. Appreciate the help.
 
Well shit, I feel like I lurnt soming myself.
I usually go, base, cal/mag, then the rest of whatever...silica at the very end with a clean measure glass.
I read probably the same information after digging into it. I've never seen that, never played with hydro before either....

Nice info...
 
I read it on a botanicare feed sheet page I was looking at.
I 💯 never noticed it in writing before.
Next run I'm going to try to see it threw.
The nutrients I'm using now want the one additive first then the bases....so the mixing silica then cal/mag
Sounds like a "pita" already...
Jacks 321 or Neptune sound better already for next time
 
Sometimes I never use it, but I have the past few times every time I added that rhino skin and calcium magnesium. Never let the rhino skin set at all. I would wait a few minutes. Stir it up a little longer than I was it. I figured it’d be in pH perfect I was good to go.
 
brother thats one of the things im most afraid of in life, and every year when i get older im even more afraid.

is it something that runs in your family tree? many of my family members have passed due to it and in many different ways. my dad passed back in 2020 brain cancer and my mom back in 2013 with stomach and many other organ issues.

you dont know you got it until you got and then its usually to late for us normal ppl out here.

just keep fighting best you can for as long as you can.



prays brother ..
 
Thanks my friend and friends.
I have multiples. Going to cut at least 4. Not wanting to set up the other tent because of the weather. I may have to. They are a little tight for me. I did pull a few the other day. Just to small. I have others behind these so I’m not going to over grow to much.
IMG_3077.jpeg
 

Attachments

  • IMG_3078.jpeg
    IMG_3078.jpeg
    419.5 KB · Views: 1
  • IMG_3079.jpeg
    IMG_3079.jpeg
    383 KB · Views: 1
  • IMG_3082.jpeg
    IMG_3082.jpeg
    297.7 KB · Views: 2
  • IMG_3081.jpeg
    IMG_3081.jpeg
    269.7 KB · Views: 2
  • IMG_3080.jpeg
    IMG_3080.jpeg
    219.4 KB · Views: 2

Forum statistics

Threads
4,308
Messages
292,055
Members
2,367
Latest member
theo
Back
Top Bottom