Today I will be washing pin heatsink cobs (16), I have redone these lights almost every time.
This is just a little short, running down close reduces the spread on the ends.
Anyone else build a component type setup?
I have two identical frames over my uc. I started with one 3x3, but didnt offer any flexibility for plant height and tough leaning under it down low.
Even that doesn’t always work, always one that want to hug the ground. ?
I’m going to extend the frame and add (2) more Cree 3590 35k cobs to each frame. I will have to extend the cob rail frames to accommodate the extra length.
Some may get a kick out of my qb mount. I have a aluminum sheet I cut to mount them on now. I just threw those in there to see, HLG 288v1 on a HLG 185-54 driver, too inexpensive not to try.
I have some 3k boards for another light.
Basicallly, I have a frame and these cob frames just lay in it. The qb will lay in between the cob rails.
The ARA strips bolt on and mount the FR puck on it.
It makes the light so much more manageable, not wrestling with all the weight at one time.
I love messing with this stuff. You’ll have to call the power company if you want to know usage, I can tell you when there on. ?
You can kick me for wire management, but won’t do any good!
I’m a rough carpenter! ?
View attachment 8779